After a period of use, Samsung washing machines often appear error codes that make the washing machine inefficient or even inoperable. Some of the most common error codes make the washing machine make an annoying sound, the water supply to the washing machine is weak, the door does not close / open... The washing machine repair technicians working in Hanoi advise We should find out the meaning of the error code that appears on the control screen before contacting the repair unit. Because there are errors that you can completely repair yourself at home, below are the most common error codes commonly found on Samsung washing machines.
See more: https://dienlanhdanhdat.vn/
Error code E8: Abnormal water temperature: Synthetic fabric washer water temperature 60 degrees C: Delicate fabric washer water temperature 50 degrees C. Wool fabric washer temperature 40 degrees C. At time Initial water supply, if the water temperature does not match the above steps, the water will be drained and will be refilled within 2 minutes (abnormal frequency is 25.24KHz). This error can be cleared with Power S/w OFF. Error code E7: Abnormal water supply pressure valve signal frequency. Low frequency valve 30.00 KHz. High Frequency Valve 15.00KHz. Check the steam pipe of the valve, check the float valve. Error code E5,E6: Error due to hot water temperature sensor. Hot water temperature 40 degrees Celsius, heating time lasts 05 minutes or 2 degrees Celsius 10 minutes after heating is started. Error code E4: Unbalance, open the door cover. The machine is not balanced, the clothes are not balanced. Adjust the machine, arrange the clothes in the box. Check the safety lid switch, close the lid.
See more: https://dienlanhdanhdat.vn/dich-vu-sua-may-giat/
Error code E3: Drain problem: Check drain valve, drain hole is clogged. The drain hose is clogged or too high. Error code E2: The problem of water leveling into the machine: The level sensor is not working stable, abnormal. Check the zac contact at the float or replace the valve with a new one or the PCB is damaged. Code E1: Supply water to the machine. The water supply is not enough flow and pressure, the water supply time lasts 20 minutes, the machine will report an error. Check the water supply, filter mesh, low water pressure height 2.5 meters. Code 5D: Lots of soap bubbles during washing. Remove soap bubbles from the machine. Then turn the machine back on. When it finishes washing the SD code will flash in turn. Fix: To prevent it, cut down on foaming detergents. Code 2E: High/lower voltage than normal. Fix: Restart cycle. If the code reappears, call for repair service. Code 3E: current detected. Fix: Restart cycle. If the code reappears, call for repair service. Code TE: Water sensor temperature problem.
See more: https://dienlanhdanhdat.vn/sua-chua-may-giat-samsung/
Fix: Restart cycle. If the code reappears, call for repair service. Code LA: Engine speed sensor problem. Fix: Restart cycle. If the code reappears, call for repair service. Code E2: Key is blocked. Fix: Call for repair service. Code 0E: Error in water level sensor. Fix: Call for repair service. Code PF: Loss of Electric service while washing machine is running. Fix: Restart the cycle by pressing the Start/Pause button. Code 5R: Problem with control. Fix: Call for repair service. Code NF: Water supply valve does not allow water to pass. Fix: Check the valve filter is dirty, the water supply has no water. Code ND: Your washing machine is not draining. It can also mean that the pipe has a minor blockage while draining. (The drain valve is not working.) Fix: Before calling for service. Follow these steps:
